Great Change Regular Switch To Dimmer
Use your flat head screwdriver and screw the faceplate in with the two included screws.
Change regular switch to dimmer. A permit and inspections may also be required. Replacing a dimmer switch. Then use a screwdriver to remove the plastic wall plate.
Do not proceed unless you are 100 sure that the power has been disconnected or you risk being electrocuted which may cause severe injury or death. Wiring a light switch to replace a dimmer switch you can replace the dimmer switch with a regular light switch only from what you have described you need to install a 3 way light switch not a single pole light switch. Electrical codes and inspections.
There are also three way dimmers that work with regular three way switches to provide dimmer control at one of the two switch locations the regular switch just turns the light on an off. The black wire to the lone screw on the 3 way light switch. Unscrew and remove the switch plate.
Unscrew the switch from the electrical box and pull it out with the wires still attached. Be sure to turn the power back on and test it out to make sure it fully works. If you re replacing a standard toggle switch that controls a light from a single location you ll need a single pole dimmer.
Test the dimmer switch that you d like to replace to be sure that it no longer has power. Be aware that all dimmer switches have larger bodies than. Once the switch is secured take the faceplate and place it over the switch.
Replace a dimmer switch with a light switch reviewing the. Then use a voltage tester to make sure that the circuit is dead. Most dimmer switches have 2 wires going to them as do regular switches.